Equipment/LaserPro Mercury II: Difference between revisions
no edit summary
No edit summary |
|||
| (7 intermediate revisions by 3 users not shown) | |||
Line 1:
{{EquipmentInfobox
|name=LaserPro Mercury II<!-- Name of the item. -->
|model=LaserPro Mercury II <!-- Model -->
|subcat=CNC <!-- Sub-category if one exists. Please check main listing to see other categories contained within the main one -->
Line 12:
|maintainers=Jimallanson<!-- If someone is nominated as managing the upkeep of this item, please list them here. No links please; it currently breaks the template. -->
}}
Cutting bed size 63.5cm x 45cm
[https://www.manualslib.com/manual/797833/Laserpro-Mercury-Ii.html LaserPro Mercury II Manual]
== Basic Safety ==
Line 48 ⟶ 49:
== Materials ==
Note Work In Progress always do a test cut first.
The laser cutter has been tested with acrylic and laser-safe MDF so far, we've purchased this from [https://www.kitronik.co.uk/ Kitronik]. If you want to try a new material (and it's not on the dangerous materials list) please let the Trustees know first.
Line 56 ⟶ 59:
|Acrylic || any || Light Raster Engrave || ?|| ?|| 1 || Required
|-
|Acrylic || 3mm || Vector Cut ||
|-
|MDF || 3mm || Vector Cut ||
|-
|MDF || 6mm || Vector Cut ||
|-
|MDF || any || Raster Engrave || ? || ? || 1 || Required
|-
|Rubber Stamp|| any || Raster Engrave || ? || ? || 1 || Required
|-
|Acetal|| 6mm || Vector Cut|| 1.0 || 100 || 1 || Required
|-
|. || || || || || ||
|-
|. || || || || || ||
|}
Note: Do not clean acrylic with Alcohol (e.g Isopropanol)
== Using the Laser Cutter (WORK IN PROGRESS)==▼
# Turn the laser cutter on with the top switch▼
# Set the bed height as per training with the calibration tool, press ↑ then up/ down (F4/F3)
# Close lid
# Prepare the file as per the section below
# once file is set to the laser, press
# Turn on the Extractor unit (BOFA-AD400TS)
# Press
# When the job is complete,
== Preparing Files
# Open the
#
# Position your cut in the bed
# For each layer in your design:
# Double click the layer and set the colour where black is cut first then red (eg use black for internal, that red to cut the outer last)
# File -Print- print
# Pen (tab)- Set the power and speed for each layer, note unlike the glass tubed lasers this one can be ran at 100% without damaging the laser.
#for rasters, adjust laser power in raster menu if needed.
# Once all layers have been set, click
== Troubleshooting ==
Line 94 ⟶ 103:
Q: The laser cutter froze part way through a job.
A: Power cycle the laser cutter, it should offer an option to resume from where it stopped????? (untested on mercury cutter)
Q: Why aren't curves showing on my imported DXF in 2DDES?
A: When exporting DXF from OnShape you need to select "Export splines as polylines". Some lines may still not show depending on exported version compatibility (more investigation needed).
| |||